Circuit Description
WARNING: This page is about a different variant/trim than selected.
PCM reads Heated Oxygen Sensor (HO2S) activity for 100 seconds. During this period, PCM counts the number of Lean/Rich (L/R) and Rich/Lean (R/L) switches.
With this information, an average time for all transitions can be determined. PCM then divides R/L average by L/R rich average to obtain a ratio. If HO2S ratio is not within range, DTC P1134 will set.
Conditions for setting DTC:
- No fuel trim, injector or HO2S 1 heater circuit DTCs set.
- No ECT, IAT, MAF, MAP, or TP sensor DTCs set.
- No EGR or EVAP DTCs set.
- Engine operating in closed loop mode.
- Conditions present during 100 second monitoring period.
- TP angle value 10-20 percent.
- Ratio of average response times not 3.00-0.75 on VIN 1.
- Ratio of average response times not 4.50-0.50 on VIN K.