LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Forward Control P30, 6.5 F, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - Tests W/Codes - 7.4L) >> Diagnostic Trouble Codes >> DTC P0341 - Camshaft Position Sensor (CMP) Circuit Performance >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different variant/trim than selected.
  1. Perform POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK , then go to next step.
  2. Check for intermittent short to voltage or electromagnetic interference (i.e., wires running along side spark plug wires, high power transmitters such as mobile radios) in camshaft position sensor wires. If a problem is found, go to next step. If no problem is found, go to step 4).
  3. Repair short to voltage or EMI interference as necessary. After repairs, go to next step.
  4. Using scan tool, select DTC, CLEAR INFO. Start and warm engine to normal operating temperature. Select DTC, SPECIFIC, then enter this DTC. Operate vehicle within the conditions for setting this DTC. If scan tool indicates that this test ran and passed, go to next step. If scan tool does not indicate that this test ran and passed, repeat step 2).
  5. Using scan tool, select CAPTURE INFO, REVIEW INFO. If any undiagnosed DTCs are displayed, go to applicable DTC test.
scientia non olet · About LEMON Manuals