LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Forward Control P30, 6.5 F, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - Tests W/Codes - 7.4L) >> Diagnostic Trouble Codes >> DTC P0160 - Ho2S Insufficient Activity Bank 2, Sensor 2 >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different variant/trim than selected.
  1. Perform POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK , then go to next step.
  2. Connect scan tool. Warm engine to normal operating temperature. Run engine at greater than 1200 RPM for 2 minutes. If scan tool indicates closed loop, go to step 5). If scan tool does not indicate closed loop, go to next step.
  3. Turn ignition off. Disconnect HO2S connector. Connect jumper wires between ground, and HO2S ground and HO2S signal circuits of HO2S connector (VCM side). Turn ignition on, with engine off. If scan tool HO2S voltage is less than .2 volt, go to step 7). If HO2S voltage is not less than .2 volt, go to next step.
  4. Remove jumper wires and reconnect HO2S connector. Turn ignition off. Disconnect Blue VCM connector. Using test light, probe VCM connector HO2S signal circuit to battery voltage. If test light illuminates, go to step 6). If test light does not illuminate, go to step 9).
  5. DTC is intermittent. Check if additional DTCs are set. If any additional DTCs are set, go to affected DTC test. If not additional DTCs are set, see DIAGNOSTIC AIDS.
  6. Check for open in HO2S signal circuit. If circuit is open, go to step 11). If circuit is okay, go to step 8).
  7. Check for poor connection at HO2S connector. If connection is faulty, go to step 11). If connection is okay, go to step 10).
  8. Check for poor connection at VCM connector. If connection is faulty, go to step 11). If connection is okay, go to step 12).
  9. Repair open in HO2S ground circuit. After repairs, go to step 13).
  10. Replace HO2S. After replacing sensor, go to step 13).
  11. Repair circuit as necessary. After repairs, go to step 13).
  12. Replace VCM. Program replacement VCM using required equipment. After replacing VCM, go to next step.
  13. Using scan tool, select DTC, CLEAR INFO. Start and warm engine to normal operating temperature. Select DTC, SPECIFIC, then enter this DTC. Operate vehicle within the conditions for setting this DTC. If scan tool indicates that this test ran and passed, go to next step. If scan tool does not indicate that this test ran and passed, repeat step 2).
  14. Using scan tool, select CAPTURE INFO, REVIEW INFO. If any undiagnosed DTC(s) are displayed, go to applicable DTC test.
scientia non olet · About LEMON Manuals