LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Forward Control P30, 6.5 F, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - Tests W/Codes - 5.7L) >> Diagnostic Trouble Codes >> DTC P1154 - Ho2S Transition Time Ratio Bank 2, Sensor 1 >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different variant/trim than selected.
  1. Perform POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK , then go to next step.
  2. Install scan tool. Check if any other DTCs are set. If any other DTCs are set, go to applicable DTC test. If no other DTCs are set, go to next step.
  3. Start engine and warm engine to normal operating temperature. Using scan tool, monitor HO2S while operating engine at a steady speed of 1200-2000 RPM for 2 minutes. After 2 minutes, if HO2S bank 2, sensor 1 voltage rapidly swings greater than and less than .3-.6 volt, go to next step. After 2 minutes, if HO2S bank 2, sensor 1 voltage does not rapidly swing greater than and less than .3-.6 volt, go to step 5).
  4. Observe scan tool with engine running at 1200-2000 RPM. If scan tool indicates closed loop operation, see DIAGNOSTIC AIDS. If scan tool does not indicate closed loop operation, go to step 8).
  5. Check if HO2S bank 2, sensor 1 voltage remains within .3-.6 volt longer than it swings outside of .3-.6 volt. If voltage remains within specification longer, go to step 10). If voltage does not remain within specification longer, go to next step.
  6. Check for poor connection at VCM connector. If a problem is found, go to step 10). If no problem is found, go to next step.
  7. Check for poor connection at HO2S bank 2, sensor 1. If a problem is found, go to step 10). If no problem is found, go to next step.
  8. Replace HO2S. After replacing HO2S sensor, go to step 11).
  9. Check leaded fuel, incorrect gasket sealer and over rich operation as possible causes of HO2S contamination. If a problem is found, go to next step. If no problem is found, go to step 11).
  10. Repair or replace as necessary. After repairs, go to next step.
  11. Using scan tool, select DTC, CLEAR INFO. Start and warm engine to normal operating temperature. Select DTC, SPECIFIC, then enter this DTC. Operate vehicle within the conditions for setting this DTC. If scan tool indicates that this test ran and passed, go to next step. If scan tool does not indicate that this test ran and passed, repeat step 2).
  12. Using scan tool, select CAPTURE INFO, REVIEW INFO. If any undiagnosed DTCs are displayed, go to applicable DTC test.
scientia non olet · About LEMON Manuals