Circuit Description
WARNING: This page is about a different variant/trim than selected.
EVAP emission system includes the following components: fuel tank, EVAP vent solenoid, fuel tank pressure sensor, fuel pipes and hoses, vapor lines, fuel cap, EVAP emission canister, purge lines, and EVAP purge solenoid.
Conditions for setting DTC:
- No ECT, HO2S, IAT, MAP, ODM, TP or VSS sensor DTCs set.
- DTC P0125 not active.
- Fuel level 12.5-87.5 percent.
- Vacuum decay for a period of at least 15 seconds.
- Vacuum less than 7 in. H2O for less than 25 seconds.
- Vacuum greater than .1 in. H2O for longer than 35 seconds.