Circuit Description
Three-Way Catalytic (TWC) converter controls emissions of hydrocarbons (HC), carbon monoxide (CO) and oxides of nitrogen (NOx). Catalyst within converter promotes a chemical reaction which oxidizes HC and CO present in exhaust gas, converting them into water vapor and carbon dioxide. Catalyst reduces NOx, converting it to nitrogen. VCM monitors this process using HO2S located in exhaust stream after catalyst.
HO2S produces a signal indicating oxygen storage capacity of catalyst and indicates catalyst's ability to convert exhaust emissions effectively. If catalyst is properly functioning, HO2S signal will be less active than other HO2S located further upstream from catalyst. DTC P0430 will set is HO2S signal is outside of acceptable range for an extended period of time, indicating 3-way catalytic converter oxygen storage capacity is below acceptable threshold.
Conditions for setting DTC:
- No AIR, ECT, EGR, EVAP, HO2S, IAT, MAF, MAP, TP and VSS DTCs are set.
- No misfire DTCs are set.
- No fuel trim DTCs are set.
- Engine run time greater than 6 minutes.
- ECT greater than 169°F (76°C) but less than 244°F (118°C).
- Engine in closed-loop operation.
- IAT greater than 19°F (-7°C) but less than 167°F (75°C).