LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Forward Control P30, 6.5 F, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - Tests W/Codes - 5.7L) >> Diagnostic Trouble Codes >> DTC P0133 - Ho2S Slow Response Bank 1, Sensor 1 >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different variant/trim than selected.
  1. Perform POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK , then go to next step.
  2. Check if any other HO2S DTCs are set. If any other HO2S DTCs are set, go to applicable DTC test. If no other HO2S DTCs are set, go to next step.
  3. Operate engine at idle. Using scan tool, monitor HO2S voltage. If voltage gradually changes by 150 mV, go to step 8). If voltage does not gradually change by 150 mV, go to next step.
  4. Disconnect HO2S harness connector. Using test light connected to ground, probe test light to HO2S harness connector terminal "D". If test light illuminates, go to next step. If test light does not illuminate, go to step 6).
  5. Connect test light between sensor harness connector terminals "C" and "D". If test light illuminates, go to step 15). If test light does not illuminate, go to step 10).
  6. Check for open HO2S fuse. If fuse is open, go to step 11). If fuse is okay, go to next step.
  7. Check HO2S connections. Repair as necessary. After repairs, go to step 13). If connections are okay, go to step 12).
  8. Remove HO2S and check sensor for contamination. If sensor is contaminated, go to step 14). If sensor is not contaminated, go to next step.
  9. DTC is intermittent. Check for additional DTCs set. If additional DTCs are set, diagnose affected DTCs. If no additional DTCs are set, see DIAGNOSTIC AIDS.
  10. Repair open in HO2S ground circuit. After repairs, go to step 16).
  11. Repair short to ground in HO2S ignition feed circuit. Replace HO2S fuse. After repairs, go to step 16).
  12. Repair open in HO2S ignition feed circuit. After repairs, go to step 16).
  13. Repair as necessary. After repairs, go to step 16).
  14. Repair source of HO2S contamination. After repairs, go to next step.
  15. Replace HO2S. After replacing sensor, go to next step.
  16. Using scan tool, select DTC, CLEAR INFO. Start and warm engine to normal operating temperature. Select DTC, SPECIFIC, then enter this DTC. Operate vehicle within the conditions for setting this DTC. If scan tool indicates that this test ran and passed, go to next step. If scan tool does not indicate that this test ran and passed, repeat step 2).
  17. Using scan tool, select CAPTURE INFO, REVIEW INFO. If any undiagnosed DTC(s) are displayed, go to applicable DTC test.
scientia non olet · About LEMON Manuals