Removal & Installation (Semi-Floating Axle)
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 1999 Pontiac Montana, 1999 Oldsmobile Silhouette, 1999 Oldsmobile Bravada, 1999 GMC Yukon, and 1999 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
Ensure parking brake is released. On Savana and Express, remove left kick panel. Place parking brake lever in full upright position. With an assistant in vehicle, raise and support vehicle. Pull rearward on front of cable strand until parking brake lever reaches its full reset position. Insert a pin into parking brake lever to hold tension. See Fig 1. On all models, remove wheel. Reference mark rear brake drum-to-axle. Remove brake drum (if necessary, back off adjuster wheel before removing brake drum). To install, reverse removal procedure. Adjust rear brake shoes. See REAR BRAKE SHOES under ADJUSTMENTS.