LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Forward Control P30, 6.5 F, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Disc Brakes & Drum Brakes) >> Adjustments >> Parking Brake >> "C" Series With Transmission-Mounted Parking Brake

"C" Series With Transmission-Mounted Parking Brake

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 1999 Pontiac Montana, 1999 Oldsmobile Silhouette, 1999 Oldsmobile Bravada, 1999 GMC Yukon, and 1999 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove clevis pin from lever assembly. Apply parking brake pedal 18 degrees. Insert a.125" (3 mm) pin into locating hole in pedal assembly. Push pedal downward until pin contacts parking brake bracket outer flange.
  2. Using small length of cable or chain and a turnbuckle, install Spring Scale (J-35999) between lever assembly and vehicle frame. See Fig 1. Tighten turnbuckle until spring scale indicates 50 lbs. (22.7 kg).
  3. Loosen clevis nut (at cable end). Turn clevis until clevis pin slides freely into lever assembly with all slack removed from cable. Install clevis pin and retain with a cotter pin. Tighten clevis nut. Remove spring scale. Remove pin from pedal assembly. Release parking brake. Ensure drum rotates freely.
Fig 1: Installing Spring Scale On Transmission-Mounted Parking Brake Assembly ("C" Series)
G91F13511Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals