LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Forward Control P30, 5.7 R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Axle Bearing & Oil Seal (Semi-Floating Axle) >> Removal (Except Astro, Safari, & "S" & "T" Series)

Removal (Except Astro, Safari, & "S" & "T" Series)

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 1999 Pontiac Montana, 1999 Oldsmobile Silhouette, 1999 Oldsmobile Bravada, 1999 GMC Yukon, and 1999 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Remove wheel and brake drum. Loosen differential cover plate and drain lubricant from axle. Remove cover plate. Remove pinion shaft lock bolt. See Figure and Figure .
  2. On locking differential models, remove pinion shaft part way. Rotate differential case until pinion shaft contacts axle housing. Using screwdriver, rotate "C" lock until it aligns with thrust block. On all models, push axle shaft toward center of vehicle and remove "C" lock from end of axle shaft.
  3. Remove axle shaft from axle housing. Using seal remover, remove seal from axle housing. Remove bearing using slide hammer and Bearing Puller (J-23689) on 8 1/2" and 8 5/8" ring gear, or (J-29712) on 9 1/2" ring gear.
scientia non olet · About LEMON Manuals