LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Corvette 2D Convertible, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Symptom Testing >> Seat Belt Indicator Inoperative

Seat Belt Indicator Inoperative

  1. Disconnect seat belt switch connector. See COMPONENT LOCATIONS  table. Using DVOM, check resistance between seat belt switch connector terminal "B" (Black wire) and ground. If resistance is less than 2 ohms, go to step 3). If resistance is not less than 2 ohms, go to next step.
  2. Repair open or high resistance in circuit No. 150 (Black wire) between seat belt switch and ground. Recheck system operation.
  3. Connect a fused jumper wire between seat belt switch connector terminals "A" (Black/White wire) and "B" (Black wire). If seat belt indicator illuminates, go to next step. If seat belt indicator does not illuminate, go to step 5).
  4. Replace seat belt switch. Recheck system operation.
  5. Disconnect instrument cluster connector. Using DVOM, check resistance between instrument cluster connector terminal B2 (Black/White wire) and seat belt switch connector terminal "A" (Black/White wire). If resistance is less than 2 ohms, go to step 7). If resistance is not less than 2 ohms, go to next step.
  6. Repair open or high resistance in circuit No. 238 (Black/White wire) between instrument cluster and seat belt switch. Recheck system operation.
  7. Replace IPC. See INSTRUMENT PANEL CLUSTER  under REMOVAL & INSTALLATION. Recheck system operation.
scientia non olet · About LEMON Manuals