MM6 (F-body) Manual Transmission

REMOVAL PROCEDURE





1. Raise and suitably support the vehicle.
2. Disconnect the electrical connector (1) from the vehicle speed sensor (2).





3. Remove the bolt attaching the vehicle speed sensor.
4. Remove the vehicle speed sensor.

INSTALLATION PROCEDURE
1. Install a new O-ring seal to the vehicle speed sensor.
2. Install the vehicle speed sensor.





3. Install the vehicle speed sensor bolt.
^ Tighten the vehicle speed sensor bolt to 10 Nm (89 inch lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.





4. Install the electrical connector (1) to the vehicle speed sensor (2).
5. Lower the vehicle.