Parking Lock Cable: Adjustments

INSPECTION / ADJUSTMENT PROCEDURE
Inspect the cable for functional operation. Complete the following procedure:
1. Place the shift lever in Park. Place the key in the LOCK position. Ensure that you cannot move the shifter lever to another position. The ignition key should be removable from the column.
2. Place the key in the RUN position. Place the shift lever in Neutral. Ensure that you cannot turn the key to the LOCK position.
3. If the above conditions are met, the system is properly adjusted. Go to step 5.
4. If the above conditions are not met, move the button to the UP position, and readjust the cable. Then, push the button down and recheck operation.
5. If you cannot remove the key in the Park position, move the button to the UP position. Then, move the cable connector nose rearward until the ignition key can be removed.
6. Snap the button down.
7. Reinstall the cable into the park/lock clip in order to ensure correct routing.