LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Camaro V8-5.7L VIN G >> Repair and Diagnosis >> Steering and Suspension >> Steering >> Steering Gear >> Service and Repair >> Unit Repair >> Rack Bearing Preload (on-Vehicle Adjustment)

Rack Bearing Preload (on-Vehicle Adjustment)

ADJUST
1. Loosen adjuster plug lock nut (15) and turn adjuster plug clockwise until it bottoms in gear assembly (30), then back off 50 degrees to 70 degrees (approximately one flats).
2. Make adjustment with front wheels raised and steering wheel centered. Be sure to check returnability of the steering wheel to center after adjustment.
3. Lock nut (15) to adjuster plug.

Tighten
^ Lock nut (15) to 68 Nm (50 ft. lbs.) while holding adjuster plug stationary.
scientia non olet · About LEMON Manuals