Power Steering Fluid Reservoir Bracket

REMOVE OR DISCONNECT
1. Reservoir (10) from brackets (16).
^ Using wire or equivalent, secure reservoir in an upright position to avoid leakage.
2. Raise and suitably support vehicle.
3. Elecrical harness from brackets (16).
4. bolt/screw (37).
5. Nuts (38).


INSTALL OR CONNECT
1. Nuts (38).
^ Tighten nuts (38) to 12 Nm (107 in lb)
2. bolt/screw (37).
^ Tighten bolt/screw (37) to 50 Nm (37 ft lb)
3. Elecrical harness to brackets (16).
4. Lower vehicle.
5. Reservoir (10) to brackets (16).