Bracket Replacement - Knee Bolster

REMOVAL PROCEDURE




1. Remove the rear compartment lid release switch, if equipped.




2. Remove the I/P knee bolster bolts (3).
3. Remove the I/P knee bolster (2).
4. Remove the I/P knee bolster bracket nuts (4).
5. Remove the I/P knee bolster bracket (5).

INSTALLATION PROCEDURE




1. Install the I/P knee bolster bracket (5).

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the I/P knee bolster bracket nuts (4).

Tighten
Tighten the I/P knee bolster bracket nuts (4) to 10 N.m (89 lb in).

3. install the I/P knee bolster (2).
4. Install the I/P knee bolster bolts (3).

Tighten
Tighten the I/P knee bolster bolts (3) to 1.9 N.m (17 lb in).




5. Install the rear compartment lid release switch, if equipped.