Turn Signal Switch: Service and Repair

REMOVE OR DISCONNECT
1. Steering column tilt wheel release lever, if equipped with cruise control. Refer to "Steering Column".
2. Access cover, if equipped with cruise control.
3. Electrical connectors, if equipped with cruise control.
4. Lever (5 or 31) by grasping firmly and pulling straight out.

INSTALL OR CONNECT
1. Position tang on lever (5 or 31) to notch in column (15).

Important: Be sure the wiper switch is in the "OFF" position before installing lever (5 or 31).

2. Lever (5 or 31) to column (15).

Important: Be sure the lever (5 or 31) is fully seated.

3. Electrical connectors, if equipped with cruise control.
4. Access cover, if equipped with cruise control.
5. Steering column tilt wheel release lever, if equipped with cruise control. Refer to "Steering Column".