Setting the Radio With Theftlock

Theftlock(TM) is a security feature which may or may not be used. It Theftlock is not used, the radio will play normally. If Theftlock(TM) is used, the radio will be useless if stolen because it will be inactive.

If the battery power is lost for any reason, a secret code must be entered again before the radio will turn ON.

Complete the following steps in order to enter a security code into the system. Do not pause for more than 15 seconds between each step:
1. Write down any number from 000 to 1999. keep the number in a safe place.
2. Turn the ignition switch to the ACCESSORY or RUN position.
3. Turn the radio system OFF.
4. Press and hold the buttons 1 and 4 together for approximately 6 seconds until a series of dashes show on the radio display.
5. Press MIN.
000 will appear on the display.
6. Press MIN again. Hold the MIN button until the last 2 digits of the code appear.
Release the button.
7. Press HR until the first 1 or 2 digits of the code appear.
8. Press AM/FM. REP will appear on the radio display.
9. Repeat Steps 5 through 7.
10. Press AM/FM. SEC will appear on the display. SEC means that the audio system is secured.

The indicator light will also flash when the ignition is OFF. If the display shows a series of dashes, the verification steps were not successful. Repeat the procedure.