Feature Customization

Many features of the universal theft deterrent system, including horn chirps, how the system arms and delay times, may be set to the customer's preference. The alarm system can also be turned off. To customize features, after the system is in programming mode, refer to the appropriate chart. Customization Charts

Programming Mode
Programming mode is necessary to customize features of the system. To set body control module (BCM) in programming mode, refer to the following procedure.

Entering Programming Mode
To enter the programming mode, perform the following:
1. Turn the ignition ON.

This will disarm the theft system, if necessary.
2. Turn the ignition OFF.
3. Remove the RADIO fuse (#17).
4. Turn the ignition to the ACC position.
The chime will sound to verify the system is in programming mode.
^ When the chime sounds once; exit lighting, delayed illumination, last door closed locking and unlocking prevention can be customized.
^ When the chime sounds twice and the vehicle is equipped with universal theft deterrent; remote lock control verification, arming method, arming verification, driver's door delay and shock sensor enable/disable can be customized.

Exiting Programming Mode
To exit the programming mode, perform the following:
1. When the programming is done, turn the ignition switch OFF.
2. Install the RADIO fuse (#17).