Intake Manifold (Upper) Installation (7.4L)

WARNING: This page is about a different variant/trim than selected.

CAUTION: Always apply a few drops of clean engine oil to the male fuel pipe ends before connecting fuel pipe fittings in order to reduce the risk of fire and personal injury. This will ensure and prevent a possible fuel leak. During normal operation, the O rings located in the female connector will swell and may prevent proper reconnecting if not lubricated.

NOTE: Manufacturer does not provide a torque sequence for upper intake manifold on 4.3L, 5.0L & 5.7L engines.

Always use NEW "O" rings when reconnecting fuel lines at rear of engine. To install, reverse removal procedure using NEW gaskets. Tighten upper intake manifold bolts to specification in sequence. See Fig 3. See TORQUE SPECIFICATIONS table.

Fig 1: Exploded View Of Intake Manifold Assembly (5.0L & 5.7L)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Exploded View Of Intake Manifold Assembly (7.4L)

Courtesy of GENERAL MOTORS CORP.

Fig 3: Intake Manifold Bolt Tightening Sequence (7.4L)

Courtesy of GENERAL MOTORS CORP.