Shudder Occurs After the TCC Has Applied

Important: Once the TCC is applied there is no torque converter (fluid coupling) assistance. Engine or driveling vibrations.could be unnoticeable before the TCC engagement.

When the sudder occurs after the TCC has applied, moist of the time there is nothing wrong with the transmission. As mentioned above, once the TCC has been applied, it is very unlikely that it will slip. Engine problems may go unnoticed under light throttle and load, but engine problems may become noticeable after TCC apply when going up a hill or accelerating, due to the mechanical coupling between the engine and the transmission.

Inspect the following components in order to avoid misdiagnosis of the TCC shudder and possibly disassembling a transmission and/or replacing a torque converter unnecessarily:

1. Spark plugs - Inspect for cracks, high resistance or broken insulator.
2. Plug wires - Look in each end. If there is a red dust (ozone) or a black substance (carbon) present, then the wires are bad. Also look for a white discoloration of the wire indicating arcing during hard acceleration.
3. Distributor cap and rotor- Look for broken or uncrimped parts.
4. Coil - Look for black on bottom indication arching while engine is misfiring.
5. Fuel injector - Filter may be plugged.
6. Vacuum leak- Engine won't get correct amount of fuel and may run rich or lean, depending on where the leak is located.
7. EGR valve - Valve may let in too much unburnable exhaust has causes engine to run lean.
8. MAP/MAF sensor - Like the vacuum leak, the engine won't get the correct amount of fuel for proper engine operation.
9. Carbon on intake valves - Restricts proper flow or air/fuel mixture into cylinders.
10. Flat cam - Valves don,t open enough to let proper fuel/air mixture into cylinders.
11. Oxygen sensor - May command engine too rich - or too lean for too long.
12. Fuel pressure - May be too low.
13. Engine mounts - Vibration of mounts can be multiplied by TCC engagement.
14. Axle joints - Check for vibration.
15. TPS - TCC apply and release depends on TPS in many engines. IF TPS is out of specification, TCC may remain applied during the initial engine crowd.
16. Cylinder balance - Bad piston rings or valves that seal poorly can cause low power in a cylinder.
17. Fuel contamination - Causes poor engine performance.