Automatic Transmission Oil Cooler Upper Hose

REMOVE OR DISCONNECT
1. Fitting (4) on radiator end of upper oil cooler hose (860).
2. Raise and suitably support vehicle.
3. Transmission oil cooler upper hose clamp (862).
4. Transmission oil cooler upper hose (860) from upper pipe (856).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the correct location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHER WISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on the threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Transmission oil cooler upper hose (860) to upper pipe (856).
2. Transmission oil cooler upper hose clamp (862).
3. Lower vehicle.
4. Fitting on radiator end of upper oil cooler hose (860).

Tighten
- Fitting on radiator end of upper oil cooler hose (860) to 27 Nm (20 ft. lbs.).