Rear Axle Torque Arm Vibration Dampener

REMOVE OR DISCONNECT
1. Rear axle torque arm dampener nut.
2. Rear axle torque arm bolt/screw, washer, and dampener.

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the correct location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Rear axle torque arm dampener, washer, and bolt/screw.

Important: Be sure collar of the dampener is positioned against the torque arm.

2. Rear axle torque arm dampener nut.
^ Tighten torque arm dampener nut to 50 Nm (37 ft. lbs.).