Rear Spring Seat

REMOVE OR DISCONNECT
1. Raise and suitably support vehicle.

Important: When raising vehicle, do not use twin post type hoist.

2. Support rear axle (13) with an adjustable lifting device.
3. Shock absorber nuts from rear axle. Refer to "Rear Shock Absorber".
4. Lower rear axle (13).

NOTICE: Do not suspend rear axle by brake hoses. Damage to hoses could result.

5. Upper insulator and rear spring. Refer to "Rear Spring".
6. Spring seat (14).

INSTALL OR CONNECT
1. Position spring seat (14).
2. Rear spring and upper insulator. Refer to "Rear Spring".
3. Raise rear axle (13).
4. Shock absorber nut to rear axle. Refer to "Rear Shock Absorber".
5. Remove rear axle support.
6. Lower vehicle.