Enabling the SIR System

INSTALL OR CONNECT
^ Turn ignition switch to "LOCK" and remove key.

1. Yellow 2-way connector and Connector Position Assurance (CPA) to passenger inflator module.
2. Instrument panel compartment door.
3. Yellow 2-way connector located near the base of the steering column and the corresponding CPA.
4. Instrument panel insulator - LH.
5. "AIR BAG" fuse to I/P fuse block.
^ Staying well away from the inflator modules, turn ignition switch to "RUN" and verify that the "AIR BAG" warning lamp flashes seven times and then turns "OFF". If it does not operate as described, perform the "SIR Diagnostic System Check".