Coil Pack Removal

Ignition Control Module:

REMOVE OR DISCONNECT
1. Bolts/screws attaching ignition coils to ignition control module.
2. Ignition coils and seals from ignition control module.
3. Ignition control module from ignition control module bracket.

INSTALL OR CONNECT
1. Ignition control module to bracket.
2. Seals and ignition coils to ignition control module.
3. Bolts/screws attaching ignition coils to ignition control module. Tighten bolts/screw attaching coils to control module to 4.5 Nm (40 in lb).