Troubleshooting Hints - Interior Lights Dimming

PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS
1. Always suspect an open lamp filament before proceeding with diagnostics.
2. Check that grounds G110, G200 and G201 are clean and tight.
3. Check I/P DIMMER Fuse 16.
^ Check for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in a continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems (refer to "Troubleshooting Procedures"). Diagnostic Aids