Daytime Running Lamp (DRL) Ambient Light Sensor Module

Remove or Disconnect
1. DRL ambient light sensor module (71) from heat and air conditioning duct.
2. Electrical connectors from DRL ambient light sensor module (71).
^ Route wiring harness from under and behind tie bar (25).

Install or Connect
1. Route instrument panel wiring harness under tie bar (25).
2. Daytime running lamp ambient light sensor module electrical connectors to module (71)
^ When connecting, push, click, then tug on daytime running lamp ambient light sensor electrical connector, not the wire.
3. Slide module (71) onto heat and air conditioning duct.