Power Brake Booster Vacuum Hose Replacement

Brake Booster Vacuum Hose (3800 VIN K):

REMOVE OR DISCONNECT
1. Reposition brake booster vacuum hose clamps (31).
2. Remove hose clamp (31) from the engine side of the vacuum hose (30), if equipped.
3. Power brake booster vacuum hose (30) from engine fitting and vacuum check valve (4).
4. Route the vacuum hose (30) under the accelerator and cruise control adjuster bracket (8), if equipped.

INSTALL OR CONNECT
1. Route the vacuum hose (30) under the accelerator and cruise control adjuster bracket (8), if equipped.
2. Power brake booster vacuum hose (30) to engine fitting and vacuum check valve (4).
3. Install hose clamp (31) to the engine side of the vacuum hose (30), if equipped.
4. Reposition brake booster vacuum hose clamps (31).