Rear Wheel Cylinder Replacement

Rear Wheel Cylinder:

REMOVE OR DISCONNECT
1. Raise and suitably support vehicle. Clean Dirt and foreign material around wheel cylinder (28) and rear brake rear pipe.
2. Brake shoes. Refer to Rear Brake Shoes Replacement.
3. Brake pipe fitting and rear brake rear pipe. Plug opening in rear brake rear pipe to prevent brake fluid loss and contamination.
4. Wheel cylinder bolts/screws (21).
5. Wheel cylinder (28).

INSTALL OR CONNECT
1. Wheel cylinder (28). Hold in place with wooden block between wheel cylinder (28) and axle flange.
2. Wheel cylinder bolts/screws (21). Tighten Wheel cylinder bolts/screws (21) to 18 Nm (13 ft. lbs.).
3. Rear brake rear pipe. Tighten Rear Brake rear pipe fitting to 17 Nm (13 ft. lbs.)
4. Brake shoes. Refer to Rear Brake Shoes Replacement.
5. Lower vehicle.
6. Bleed brake hydraulic system.