Manual Transmission

Brake Pedal:

REMOVE OR DISCONNECT
1. Negative battery cable.
2. Left side instrument panel insulator.
3. Electronic Brake Control Module (EBCM).

Stoplamp And Cruise Control Switches:

4. Cruise control release switch, stoplamp and Torque Converter Clutch (TCC) switch, and cruise control clutch switch or cruise control clutch anticipate switch if equipped, from pedal with bracket.
5. Clutch start switch from brake pedal with bracket.
6. Accelerator pedal.
7. Brake pedal pushrod pin retainer, brake pedal pushrod and brake pedal pushrod washer from brake pedal pin.
8. Clutch pedal lever pin retainer and clutch pushrod from clutch pedal pin.
9. Brake pedal nuts and brake pedal bracket bolts/screws.
10. Clutch master cylinder nuts.
11. Brake pedal with bracket.

INSTALL OR CONNECT

NOTE: When installing brake pedal with bracket, make sure that dash panel insulator material does not get pinched between brake pedal with bracket and dash panel.

1. Brake pedal with bracket.
2. Clutch master cylinder nuts.
3. Brake pedal nuts and brake pedal bracket bolts/screws. Tighten clutch master cylinder nuts to 27 Nm (20 ft. lbs.). Brake pedal nuts to 20 Nm (15 ft. lbs.) in sequence:
- Inboard upper
- Outboard lower
- Outboard upper
- Inboard lower

NOTE: Brake pedal bracket bolts/screws to 25 Nm (18 ft. lbs.).

4. Accelerator pedal.
5. Clutch pedal lever pin retainer and clutch master cylinder pushrod to clutch pedal pin. Lubricate clutch pedal pin with chassis lubricant.
6. Brake pedal pushrod pin retainer, brake pedal pushrod and brake pedal pushrod washer to brake pedal pin. Lubricate brake pedal pin with chassis lubricant.
7. Cruise control release switch, stoplamp and TCC switch, and cruise control clutch switch or cruise control clutch anticipate switch if equipped, to pedal with bracket.
8. Electronic Brake Control Module (EBCM).
9. Clutch start switch to brake pedal with bracket.
10. Left side instrument panel insulator.
11. Negative battery cable. Tighten Negative battery cable to 15 Nm (11 ft. lbs.). Adjust cruise control release switch, stoplamp and TCC switch control clutch anticipate switch.