Right Front Wheel Speed Sensor Jumper Harness

Front Wheel Speed Sensor Jumper Harness (Left Hand Shown, Right Hand Similar):

REMOVE OR DISCONNECT
1. Raise and support vehicle on suitable hoist.
2. Connector from wheel speed sensor.
3. Harness from retaining clips.
4. Grommet retainer at inner fender.
5. Lower vehicle.
6. Harness cover from right strut tower.
7. Upper jumper harness connector.
8. Pull grommet through inner fender pass through and remove jumper harness.

INSTALL OR CONNECT
1. Route new jumper harness through inner fender pass through.
2. Upper jumper harness connector.
3. Harness cover to right strut tower.
4. Raise vehicle.
5. Seat grommet into position in the inner fender.
6. Grommet retainer.
7. Harness to sensor.
8. Harness to retaining clip.