Shock Sensor: Service and Repair

Theft Deterrent Shock Sensor:

REMOVE OR DISCONNECT

CAUTION: Refer to " Battery / Service Preaution"

1. Battery negative cable.
2. Right quarter inner rear trim finishing panel (Coupe)
3. Right side trim finish panel (Convertible).
4. Electrical connector.
5. Shock sensor (9).
Clean
^ Shock sensor attaching surfaces.
Important: Shock sensor sensitivity has been preset and should require no adjustment Remove label covering and adjust only if more or less sensitivity is desired. Refer to "System Components" in this section for a description of the two sensitivity levels and adjustment procedure.

INSTALL OR CONNECT
1. Shock sensor (9).
^ Remove adhesive backing and install in original position.
2. Electrical connector.
3. Right side trim finish panel (Convertible).
4. Right quarter inner rear trim finishing panel (Coupe).
5. Battery negative cable.