Programming Mode

Programming mode is necessary to customize features of the system. To set BCM in programming mode, refer to the following procedure.

Entering Programming Mode
1. Turn ignition "ON."
^ This will disarm theft system, if necessary.
2. Turn ignition "OFF."
3. Remove "RADIO" fuse.
4. Turn ignition to "ACC" position.
^ Chime will sound to verify the system is in programming mode.
- When the chime sounds once; exit lighting, delayed illumination, last door closed locking and lockout prevention can be customized.
- When the chime sounds twice and the vehicle is equipped with universal theft deterrent; remote lock control verification, arming method, arming verification, driver's door delay and shock sensor enable/disable can be customized.
5. Program features desired using the appropriate chart(s).

Exiting Programming Mode
1. When programming is done, turn ignition switch "OFF."
2. Install "RADIO" fuse.