AIR Active Test Enable

WARNING: This page is about a different variant/trim than selected.

AIR passive test failed
No ECT sensor DTCs.
No HO2S DTCs are set.
No misfire DTCs are set.
No MAP DTCs are set.
No fuel trim DTCs are set.
No EVAP DTCs are set.
No TP sensor DTCs are set.
No IAT DTCs are set.
No MAF DTCs are set.
Power enrichment not active.
Decel fuel cut-off not active.
Air/fuel ratio is 14.7:1.
Engine speed is greater than 550 RPM.
Closed-loop for greater than 15 seconds.
Engine load is less than 50 percent.
MAF sensor is less than 100 gm/s.
Engine coolant temperature is 167-221°F (75-105°C).
IAT greater than 0°C.
Integrator is greater than .95 but less than 1 for 3 seconds.