Special Tools (Diagnostic)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1997 GMC Yukon, 1997 GMC Suburban, 1997 GMC Pickup, 1997 GMC Cab & Chassis, and 1997 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
A scan tool plugged into DLC is used to read DTCs and check voltages in system on serial data line. A scan tool is REQUIRED to retrieve vehicle information.
Computerized engine control system is most easily diagnosed using scan tool; however, other tools may aid in diagnosing problems. These tools are a tachometer, test light, ohmmeter, digital voltmeter with a 10-megohm input impedance (minimum), vacuum pump, vacuum gauge, fuel injector test lights and 6 jumper wires 6" long (one wire with female connectors at both ends, one wire with male connectors at both ends and 4 wires with male and female connectors at opposite ends). A test light, rather than a voltmeter, must be used when indicated by a diagnostic test. In addition, special jumper harnesses or testers may be required by manufacturer to facilitate diagnosis.