Diagnostic Procedures
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1997 GMC Yukon, 1997 GMC Suburban, 1997 GMC Pickup, 1997 GMC Cab & Chassis, and 1997 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
- Perform ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK. See the F - BASIC TESTING - 5.7L article. After performing OBD system check, go to next step.
- Turn ignition off. Disconnect VCM and EBCM connectors. Using DVOM, check for open in serial data circuit between VCM and EBCM. If a problem is found, go to next step. If a problem was not found, see the BRAKES SYSTEM - ANTI-LOCK article in the BRAKES section.
- Repair as necessary. After repairs, go to next step.
- Using scan tool, select DTC, CLEAR INFO. Start and warm engine to normal operating temperature. Select DTC, SPECIFIC, then enter DTC P1380. Operate vehicle within the conditions for setting this DTC. If scan tool indicates that this test ran and passed, go to next step. If scan tool does not indicate that this test ran and passed, DTC is intermittent.
- Using scan tool, select CAPTURE INFO, REVIEW INFO. If any undiagnosed DTC(s) are displayed, go to applicable DTC test.