LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1997 >> C3500 HD 6.5 F, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Engine Controls - Tests W/Codes - 4.3L) >> Diagnostic Trouble Codes >> DTC P0341 - Camshaft Position Sensor CMP) Circuit Performance >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 1997 GMC Pickup and 1997 Chevrolet Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK. See the F - BASIC TESTING - 4.3L article. After performing OBD system check, go to next step.
  2. Check for intermittent short to voltage or electromagnetic interference (i.e., wires running along side spark plug wires, high power transmitters such as mobile radios) in camshaft position sensor wires. If a problem was found, go to next step. If a problem was not found, go to step 4).
  3. Repair short to voltage or electromagnetic interference as necessary. After repairs, go to next step.
  4. Using scan tool, select DTC, CLEAR INFO. Start and warm engine to normal operating temperature. Select DTC, SPECIFIC, then enter DTC P0341. Operate vehicle within the conditions for setting this DTC. If scan tool indicates that this test ran and passed, go to next step. If scan tool does not indicate that this test ran and passed, repeat step 2).
  5. Using scan tool, select CAPTURE INFO, REVIEW INFO. If any undiagnosed DTC(s) are displayed, go to applicable DTC test.
scientia non olet · About LEMON Manuals