LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1996 >> Tahoe 2D Utility, 6.5 S >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 6.5L V8 Diesel - VIN [F & S] >> Removal & Installation >> Rear Crankshaft Oil Seal >> Installation

Rear Crankshaft Oil Seal: Installation

  1. Lubricate inner and outer diameter of seal with engine oil. Place seal on Seal Installer (J-39084). Position seal installer against crankshaft.
  2. Mount seal installer on crankshaft flange. Rotate seal installer handle until it bottoms on flange. Remove seal installer. Install flywheel, clutch (M/T) and transmission.
scientia non olet · About LEMON Manuals