Disc Brakes & Drum Brakes - "C" & "K" Series: Overhaul: Notes

NOTE: Use exploded view illustrations for overhaul of brake assemblies. See Figure-Fig 8.

WARNING: DO NOT hone master cylinder bore. Honing destroys hardened surface, causing premature piston seal failure. If bore surface is rough or pitted, replace master cylinder.

Fig 1: Exploded View Of Sliding Caliper Assembly (Typical)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Exploded View Of Rear Brake Shoe Assembly (Leading/Trailing Brakes)

Courtesy of GENERAL MOTORS CORP.

Fig 3: Exploded View Of Power Brake Booster (Dual Diaphragm)

Courtesy of GENERAL MOTORS CORP.

Fig 4: Exploded View Of Floating Caliper Assembly (Typical)

Courtesy of GENERAL MOTORS CORP.

Fig 5: Exploded View Of Power Brake Booster (Single Diaphragm)

Courtesy of GENERAL MOTORS CORP.

Fig 6: Exploded View Of Cast Iron Master Cylinder

Courtesy of GENERAL MOTORS CORP.

Fig 7: Exploded View Of Composite Master Cylinder

Courtesy of GENERAL MOTORS CORP.

Fig 8: Exploded View Of Rear Wheel Cylinder (Typical)

Courtesy of GENERAL MOTORS CORP.