LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1996 >> Lumina Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.4L V6 - VIN [X]) >> Removal & Installation >> Thermostat >> Installation

Removal & Installation: Thermostat: Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse removal procedure.
  2. Tighten housing bolts to 18 ft. lbs. (25 N.m).
  3. Tighten engine mount/strut nuts to 35 lb ft (48 N.m).
  4. Fill cooling system with appropriate mix of water and coolant.
  5. Start the engine. After the engine reaches normal operating temperature, check for coolant leaks.
scientia non olet · About LEMON Manuals