LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1996 >> Lumina Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.4L V6 - VIN [X]) >> Removal & Installation >> Oil Pan >> Installation

Oil Pan: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean gasket surfaces and bolt holes. Install a NEW gasket. Apply GM Sealant (12345739) to notches at rear main bearing cap. Install oil pan. Tighten oil pan nuts to specification. See TORQUE SPECIFICATIONS .
  2. Tighten 2 rear oil pan bolts to specification. Tighten remaining oil pan bolts to specification. To complete installation, reverse removal procedures. Fill and bleed the cooling system. See COOLING SYSTEM BLEEDING .
scientia non olet · About LEMON Manuals