LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1996 >> Lumina Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.4L V6 - VIN [X]) >> Removal & Installation >> Front Cover Oil Seal >> Removal

Front Cover Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove coolant recovery tank. Rotate serpentine belt tensioner clockwise with a wrench, and remove belt. See Figure. Remove bolt and tensioner. Raise and support vehicle. Remove right front wheel and engine splash shield.
  2. Remove flexplate/flywheel cover. Using Flywheel Holder (J-37096), remove crankshaft damper bolt. See Figure. Remove crankshaft pulley bolts and pulley. Remove heater pipe screws at coolant recovery tank bracket. Install Damper Remover (J-24420-B) onto damper. Rotate puller screw, and remove damper.
  3. Pry out old front cover oil seal with large screwdriver. DO NOT  damage crankshaft. Inspect crankshaft and front cover for scratches.
scientia non olet · About LEMON Manuals