LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1996 >> Lumina Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.4L V6 - VIN [X]) >> Removal & Installation >> Camshaft Carrier & Covers >> Removal (Left Bank)

Removal (Left Bank)

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect breather hose from cover. Disconnect spark plug wires from plugs. Remove spark plug wire cover. Remove bolts and camshaft carrier cover. Remove cover gasket and "O" rings. Remove timing belt. See TIMING BELT & CAMSHAFT TIMING PROCEDURE .
  2. Remove exhaust crossover pipe. Remove engine torque strut from between top of radiator panel and engine. Remove thermostat housing from lower intake manifold. Remove engine lift bracket. To retain lifters in carrier, install 6" long fuel line hose between camshaft and lifters (use 3/16" diameter hose for exhaust side, and 5/32" diameter hose for intake side). Remove bolts, camshaft carrier, and gasket.
scientia non olet · About LEMON Manuals