LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1996 >> Cavalier LS, 2D Convertible, 2.4 T, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Front Brake Pads >> Installation

Front Brake Pads: Installation

  1. Clean outside surface of caliper piston(s) boot with denatured alcohol. SeeFigure . Slowly compress piston(s) into bore with a "C" clamp, being careful not to cock piston(s) to one side or damage piston boot. See FRONT BRAKE CALIPER  . Using small plastic or wood tool, lift inner edge of boot next to piston and press out any trapped air. Reposition boot so it lays flat with convolutions in proper position.
  2. Install inner pad, snapping retainer into place in piston(s). Ensure pad lays flat against piston(s). Ensure boot(s) is not touching pad. Install outer pad with wear sensor at trailing edge of pad (forward wheel rotation). Ensure pad lays flat against caliper.
  3. To install remaining components, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals