LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1995 >> Forward Control 7.4 N >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front (Coil Spring) >> Removal & Installation >> Steering Knuckle >> Installation

Steering Knuckle: Installation

  1. To install, reverse removal procedure. Install NEW grease seal on steering knuckle (if removed). Tighten ball joint stud nuts to align cotter pin holes as necessary. Install tie rod end stud into steering knuckle.
  2. Install Steering Linkage Installer (J-29193 ) or (J-29194 ). Tighten steering linkage installer to 40 ft. lbs. (54 N.m) to seat tie rod taper. Remove steering linkage installer and install tie rod end stud nut.
  3. To complete installation, reverse removal procedure. Adjust wheel bearings. See FRONT WHEEL BEARINGS  under ADJUSTMENTS. Tighten bolts and nuts to specification. See the TORQUE SPECIFICATIONS . Lower vehicle and check wheel alignment. See the WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES article in the WHEEL ALIGNMENT section.
Fig 1: Separating Upper & Lower Ball Joints From Steering Knuckle
G95A27300Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals