LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1995 >> Forward Control 7.4 N >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axle - DANA 10.5" & 11" (Full-Floating). >> Removal & Installation >> Hub & Rotor Assembly >> Removal

Hub & Rotor Assembly: Removal

  1. Raise and support vehicle. Remove wheel assembly. Remove caliper from mounting bracket, and wire aside. Remove axle shaft. See AXLE SHAFTS  under REMOVAL & INSTALLATION.
  2. Bend up locking tang(s) from retaining lock nut. Using Torque Wrench and Socket Wrench Set (J-2222-C), remove wheel bearing outer retaining lock nut.
  3. Remove locking tang washer. Remove inner adjusting nut and washer (if equipped). Slide hub and rotor assembly off axle shaft tube.
scientia non olet · About LEMON Manuals