LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1995 >> Forward Control 7.4 N >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brake System & Drum Brake System - P Series Van >> Removal & Installation >> Rear Brake Drum >> Removal (10 1/2" & 11" Full-Floating Axle)

Removal (10 1/2" & 11" Full-Floating Axle)

  1. Ensure parking brake is released. Raise and support rear of vehicle. Remove wheel. Remove bolts from end of axle shaft. See Fig 1.
  2. Lightly tap axle shaft flange with soft hammer to loosen shaft. Grip rib on axle shaft flange with locking pliers. Twist axle shaft to start shaft removal. Pull axle shaft from axle housing. For removal of drum on 10 1/2" Saginaw axle, perform next step. For removal of drum on 11" Dana axle, perform step 4).
  3. Remove retaining ring and key. Using Wheel Bearing Nut Wrench (J-2222-C), remove adjusting nut. Remove washer. Remove hub and brake drum assembly (if necessary, back off adjuster wheel before removing brake drum).
  4. Bend lock washer tab away from lock nut. Using Wheel Bearing Nut Wrench (J-2222-C), remove lock nut. Remove lock washer. Remove adjusting nut and washer. Remove hub and brake drum assembly (if necessary, back off adjuster wheel before removing brake drum).
Fig 1: Exploded View Of Rear Axle Shaft, Hub & Brake Drum Assembly (Full-Floating Axle)
G91G13512Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals