LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1994 >> Suburban K2500, 5.7 K >> Repair and Diagnosis >> Transmission >> Transfer Case >> Transfer Case - Overhaul - New Venture 241 & 243 >> On-Vehicle Service >> Output Shaft Seals Replacement >> Removal & Installation

Removal & Installation

  1. Mark propeller shafts and flanges for alignment purposes during installation. Remove front or rear propeller shaft. Remove flange. Discard nut and washers. Using a screwdriver, carefully remove oil seal. Ensure seal contact surface is clean.
  2. Apply ATF to seal lip and flange seal surface. Install oil seal and flange with new washer and nut. Install front and rear propeller shafts using alignment marks. Check transfer case fluid.
scientia non olet · About LEMON Manuals