Removal & Installation (2WD)
- Remove wheel and tire assembly. Remove brake caliper and wire aside. Remove hub and rotor assembly. Disconnect speed sensor electrical connector. Remove speed sensor wire from clip on upper control arm. Remove splash shield and speed sensor assembly. To install, reverse removal procedure. Tighten wheel bearing nut to 12 ft. lbs. (16 N.m), then back off until just loose.
- Back off wheel bearing nut again, no more than 1/4 of a turn, until hole in spindle aligns with slot in wheel bearing nut. If wheel bearing nut is adjusted properly, hub end play should be .001-.008" (.03-.20 mm). If hub end play is not within specification, repeat procedure. Speed sensor air gap is non-adjustable.